Physio-control TrueCPR User Manual download pdf (Page 21)

English

Troubleshooting Tips for Data Management

Cleaning the Device

The TrueCPR device should be cleaned and inspected after each use.

1 Clean the device with a sponge or cloth that has been dampened with one of

the cleaning agents shown below:

• Quaternary ammonium compounds

• Hydrogen peroxide, 3% solution

• Sodium dichloroisocyanurate (NaDCC), 3000 ppm solution

• Chlorine bleach, 1:10 dilution with water

2 Inspect the device and cable for wear or damage. Remove from service if

damaged.

3 After cleaning, wipe off solution with a clean, damp cloth.

IMPORTANT! Do not immerse or soak the chest pad or back pad.

Storing the Device

Place chest pad onto back pad. Store in carrying bag so that battery readiness

indicator is visible.

OBSERVATION CORRECTIVE ACTION

Feedback screen appears on

TrueCPR device and

metronome sounds.

• Confirm USB cable is properly connected.

• Confirm computer is on.

• Replace USB cable.

• Use recommended USB cable (see Step 1

on page 14).

Data Transfer Failed screen

appears.

• Turn TrueCPR device off and check

connections. Then turn device on and

attempt data transfer again.

• If problem persists, contact Technical

Support.

CAUTION

POSSIBLE DEVICE DAMAGE: If the TrueCPR device will be stored for an

extended period of time, remove the batteries to prevent possible damage

due to battery leakage.

3308456-900.book Page 15 Wednesday, October 24, 2012 9:51 AM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 105 106

No comments

Physio-control TrueCPR User Manual Page 21